Cooline DWL SERIES Guía de usuario descargar pdf (Pagina 11)

USER’S GUIDE

InRow RC ACRC100 Series

7. From the Control Console menu, select System, then User Manager.

8. Select Administrator, and change the User Name and Password settings,

both of which are now defined as apc. Select Accept Changes to store the

new user name and password values.

9. Press

CTRL+C, log off, reconnect any serial cable you disconnected, restart any

service you disabled, reinstall the lower air filter, and replace the rear panel.

Display Interface LEDs

Status

This LED indicates the status of the InRow RC.

Check log

When yellow, this LED indicates that at least one new critical alarm, warning alarm, or

event has occurred since the last time the event log was viewed from the display

interface.

Warning alarm

When yellow, this LED indicates that a warning alarm condition exists and may require

your attention to prevent it from deteriorating into a critical state. A new alarm will cause

a beep every 30 seconds until you silence the alarm by pressing any function key.

Condition Description

Off The InRow RC has no power.

Solid Green The InRow RC is receiving power.

Flashing Green The InRow RC is receiving a firmware upgrade.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 102 103

Sin comentarios

Cooline DWL SERIES Guía de usuario Pagina 11